VALERII S&M GROUP 42285, Оригинальное руководство пользователя

Страница: 3 / 13

the shaft.
To guarantee that the pump works properly, the bottom of the shaft must be kept free of sludge and dirt of all
kinds.
If the lever of water sinks too far, any sludge in the shaft will dry out quickly and stop the pump from
starting-up. It is necessary, therefore, to check the submersible motor pump regularly (by carrying out start-up
tests).
The floater is adjusted in way that the pump can immediately started.
Note
！
The pump shaft should have minimum dimensions of 40×40×50cm, so that the
floating switch can move freely
.
Mains supply
Your new submersible pump is equipped with a shockproof plug according to regulations. The pump is
designed to be connected to a 230V
～
50Hz safety socket. Make sure that the socket is sufficiently secured
(min.6 Amp.) and is in excellent condition, Introduce the plug into the socket and the pump is ready to go.
Important note
！
If the main cable or plug suffers any damage from external action, repairs to the cable are prohibited.
Important
！
Qualified electrician or your ISC GmbH Customer service may only perform this work
.
Areas of use
This pump is used primarily as Cellar pump. When installed in a shaft, this pump provides protection from
flooding.
They are also used whenever water has to be moved from one place to another, e.g. in the home, agriculture,
horticulture, plumbing and many other applications.
Setting to work
After having reading these instructions carefully, you can set your pump to work, reconsidering the following
items:

Check if the pump rests on the ground of the shaft.

Check of pressure cord has been attached properly.

Check if electrical connection is 230V
～
50Hz.

Check if the socket is in good condition.

Make sure that water and humidity can never come to the mains supply.

Avoid pump running dry.
Maintenance guidelines
This submersible pump is an approved, maintenance-free high quality product, which is subject to severe