Installation time
1 hour
ÌÌ
4/11
Tools required:
1. Wire stripper pliers
2. Screwdriver set
3. Insulating adhesive tape
4. Wire-cutting pliers
5. Multimeter
6. Soldering iron
As the battery must be disconnected during installation, some data
may be lost (radio station settings, vehicle locking code, etc.)
Installation guide
1. Preparing for installation
Kit components:
1. Camera module
2. Power cable
3. USB cable
4. Positioning template
5. Cable ties
6. Cable clips
7. Remote control
8. CD-ROM
•
Before installing the system, check that the
vehicle is parked on level ground and the turn
indicators and speedometer work properly.
•
Locate the vehicle's +ACC and ground
These are generally located at the fuse block.
•
Locate the left and right turn indicator outputs
These are generally located at the fuse block, lighting control stalk
or turn indicator tell-tale.
•
Also locate the vehicle’s speed information:
either at its radio,
or at the speed output used by the GPS,
or at the ABS (under the hood).
•
Use the multimeter to check that it is indeed
speed information:
Connect the multimeter’s – connection to the vehicle's
ground, and its + connection to the located speed output
Drive a short distance to check the information;
the
reading should fluctuate between 0 and 12V.
On certain multiplexed vehicles,
the speed information is coded
and cannot
be used in unmodified form (on the Peugeot 807, for example). In this case,
you can connect an
electronic decoder
(interface) to the multiplexed cable in
order to convert the electronic data into electrical speed information that the
multimeter can recognise
.
