Page 13
Owner’s Manual - S42
ENGLISH
3.1 Lighting Instructions (Proflame II Model)
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING
If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A)
This appliance must be lighted with the remote
control. When lighting the pilot, follow these
instructions exactly.
B)
BEFORE LIGHTING, smell around the
appliance area for gas. Be sure to smell next
to the floor because some gas in heavier than
air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electrical switch.
•
Do not use any phone in your building.
•
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions. If you can not reach your gas
supplier, call the fire department.
C)
Use only the remote control to operate the
valve. Never use tools. If valve does not
operate, don’t try to repair it, call a qualified
service technician. Force or attempted repair
may result in a fire or explosion.
D)
Do not use this appliance if any part has
been underwater. Immediately call a qualified
service technician to inspect the appliance and
to replace any part of the control system and
any gas control which has been underwater.
LIGHTING INSTRUCTIONS
1.
STOP! Read the safety information above.
2.
Turn OFF electric power to the appliance.
3.
Turn gas shut-off counterclockwise
to ON position.
4.
Wait ten minutes to clear out any gas. Then
smell for gas, including near the floor. If
you smell gas, STOP! Follow B in the safety
information above on this label. If you do not
smell gas, go to the next step.
5.
Turn ON electric power to the appliance.
6.
Using the remote control, turn main flame
to ON. If the pilot does not light within 60
seconds, stop and go back to Step 4
7.
If the burner or pilot does not operate properly
after several tries, turn the gas control knob
clockwise
to OFF and call your
service technician or gas supplier.
8.
Operation of the gas valve, blower, and/or
optional light must be controlled by using the
hand held remote control. Refer to remote
instructions for detailed operation information
TO TURN OFF GAS TO APPLIANCE
1.
Turn off all electric power to the appliance
if service is to be performed (if applicable).
2.
Locate On/Off gas shut-off and turn
clockwise to
OFF. Do not force.
GAS SHUT-OFF VALVE
