MM101 – D-4E HOT MELT UNIT
23
VALCO MELTON S.L.U. Pol. Ind. Agustinos C/G 34 3116 0 ORCOYEN, NAVARRA
TEL: +34 948 321580 Fax: +34 948 326584 [email protected]
www.valcomelton.com
Warning!
If hand-held applicators are used, care should be taken to
ensure safe operation. Heat protective gloves should be
worn. Hot melt is under high pressure at the nozzle tip of the
applicator. Failure to observe could result in personal injury
(burns).
Warning!
If hand-held applicators are used, operators should not work
facing each other. Failure to observe could result in personal
injury (burns).
Warning!
If fixed applicators are used, they should be protected
from
accidental contact by the operator. Failure to observe could
result in personal injury (burns).
Warning!
Hand-held applicators require a suitable hook for
hanging
while not in use. The hook must support the weight of the
applicator with the hose. Failure to observe could result in
damage to equipment
Either hand-held or fixed applicators can be used with the unit
To connect the fixed applicators, follow these steps:
1. Mount the applicator to the desired location on the parent
machine.
2. Connect the end of the hot melt hose (Figure 5-3) to the
fluid inlet fitting on the applicator (Figure 5-4).
3. Connect the hot melt hose lead assembly’s female
connector to the lead assembly on the applicator.
Connecting the
Hot Melt Hoses
to the
Applicators
Do not place applicators where the
ambient temperature is low or where
there is a draft
