Opening the strOller chassis
FIGURE A
1. Lay the stroller flat on the floor and carefully cut the
cable tie which holds the frame. To unfold the chassis,
locate the rear legs.
NOTE: The rear centre leg is highlighted in red.
2. Holding the rear centre leg, lift the stroller upwards. Pull
the centre leg outwards as far as it can go.
FIGURE B
3. Lift the handlebar upward towards you until the stroller is
in a vertical position.
4. Secure the stroller by swinging the locking clamps
(located on both sides of the frame) and fully engaging
them tightly onto the frame.
FIGURE C
5. Press down on the basket frame locking hinge with your
hand or foot.
IMPORTANT WARNING: ALWAyS TEST ThAT ALL LATChES
ARE SECURELy ENGAGED bEFORE USE.
installing the wheels
FIGURE D
6. Pressing on the centre axle button, insert the Super Quick
Release (SQR) axle through the outside of the hub in each
wheel.
IMPORTANT: INSERT ThROUGh OUTSIDE OF ThE WhEEL
(ThE SIDE WhICh DOES NOT hAvE ThE NyLON bRAkE COG).
A
C
B
D
Outside
wheel hub
Axle button
Nylon
brake
cog
