FIGURE E
7. Press the axle button and insert the protruding long axle
into the opening on the stroller frame beneath the brake.
Release the axle button when wheel is in place to secure.
NOTE: Ensure that the brake pedal is fully retracted, so that the
brake pin (highlighted in red) does not obstruct the wheel cog
from fully engaging the housing.
8. Repeat the procedure for the other side. TEST that each
wheel is securely engaged by pulling on it.
9. To remove the wheel, simply press the axle button in
the centre of the wheel hub and simultaneously pull the
wheel outward.
IMPORTANT NOTE: If your brakes do not engage, check to see the
nylon brake cogs are on the INSIDE of each wheel when it is
attached to the chassis. If not, remove the wheel and SQR axle
and re-insert the SQR axle from the other side of the wheel, so
that the cog will be on the inside of the wheel.
FIGURE F
Your Twin Tri-mode stroller utilizes our unique and revolutionary
new DUAL TRIMODE ™ front swivel system:
10. Tilt the stroller frame upward so that it rests on the
handle and the rear wheels.
11. Insert each fork shaft respectively into each
TRI-MODE housing till it “clicks” into place.
IMPORTANT: before use, always test that the fork is securely
engaged in the housing by pulling on it.
To remove the front fork:
12. Rotate the TRI-MODE selection dial to the centre (45°)
position.
13. Tilt the stroller frame upward so that it rests on the
handle and the rear wheels.
14. Press the centre release button and pull the fork away
from the mechanism.
FIGURE G
The unique TRI-MODE™ swivel system is as flexible as it is
functional over a variety of terrains and uses.
15. LOCK: This position is best for use on extremely rough or
soft terrain such as sand etc which inhibit wheel swivel.
To lock your wheel, rotate the dial to the “LOCK” position.
Swivel the wheel around till it locks into position.
16. O: The central position locks the wheel into a tight 45°
swivel arc. This provides more stability for use with a
toddlerseat or when going down inclines so as not to turn
so sharply!
17. SWIVEL: This position allows full, unfettered Installing/
Removing your hoods 360° swivel action.
E
F
G
9
b
a b
y
lo
ck
sw
iv
el
14
