THe FRONT baR
FIGURE E
10. Remove the plugs from the nylon housing at either side of the
stroller frame by pressing each inner “release button” and
pulling the plug upward. (Retain for future use, plugs must be
inserted if the bar is removed and the housings are not in use
for a Valco Baby approved accessory)
11. Insert the bar ends into the nylon housing located on either
side of the frame. Be sure that the bar is securely engaged
12. Adjust the front bar by simultaneously pressing the buttons
and swivelling the bar (forward or backward). NEVER use your
stroller with the front bar in the lowest position. This position is
ONLY for use when folding the stroller!
13. To remove the front bar: Feeling the side of the nylon housing
that sits below the frame at each side (facing inward), locate the
release “button.”
14. Press the release button inward while simultaneously pushing
upward on the bar housing. Repeat for the other side.
IMPORTANT WARNING: THE FRONT BAR IS NOT
A RESTRAINING DEVICE. ALWAYS RE-INSERT
THE PLUGS INTO THE HOUSING WHEN THERE IS
NOTHING INSERTED.
FRONT WHeel FORKs
FIGURE F
Your stroller utilizes our TRI-MODE™ front swivel system:
15. To install the front fork, rotate the TRI-MODE selection dial to
the centre (45°) position.
16. Tilt the stroller frame upward on the rear wheels.
17. Insert the fork shaft into the TRI-MODE housing till it “clicks”
into place.
To remove the front fork:
18. Rotate the TRI-MODE selection dial to the centre (45°)
position.
19. Tilt the stroller frame upward on the rear wheels.
20. Press the centre release button. The fork will then be released,
pull the forks downward to remove
sWIVel sysTem
FIGURE G
The TRI-MODE™ swivel system is as flexible as it is functional over
a variety of terrains and uses.
21.
LOCK:
This position is best for use on extremely rough or soft
terrain such as sand etc which inhibit wheel swivel. To lock your
wheel, rotate the dial to the “LOCK” position. Swivel the wheel
around till it locks into position.
22.
O:
The central position locks the wheel into a tight 45° swivel
arc. This provides more stability for use with a toddlerseat or
when going down inclines.
23.
SWIVEL:
This position allows full, unfettered swivel action.
IMPORTANT: ALWAYS TEST THAT THE FORK IS
SECURELY ENGAGED IN THE HOUSING.
FOlDING yOUR sTROlleR
FIGURE H
24. Fold the hood back up against the handle.
25. Release the locking clamps at either side of the stroller.
13
9
E
F
G
H
