UsING THe exPaNDa HOOD
FIGURE Q
The Expanda hood unzips, increasing the size of your standard
hood to give greater coverage and protection from the sun and
weather for your child.
To open the Expanda Hood:
42. Locate the zip in the center of the Expanda Hood and unzip
completely
43. Gently pull the Expanda Hood forward until it is reaches its
full extension.
To close the Expanda Hood:
44. Gently push the Expanda Hood back, allowing the middle
section to fold in on itself.
45. Carefully zip the Expanda Hood closed.
IMPORTANT: ALWAYS TAKE CARE WHEN CLOSING THE
EXPANDA HOOD TO AVOID THE zIPPER CATCHING ON THE
ENCLOSED FABRIC
UsING THe aCCessORy zIP IN sysTem
FIGURE R
Your Expanda hood is fitted with a front accessory zip system
which is used with a variety of handy optional accessories
these include our Valco 80% UV Zip in Mesh, Valco
Raincover and more
TO ATTACH OR REMOVE THE ACCESSORY:
46. Insert the zip track at the front of the Expanda
hood into the zip housing of the accessory. When
together, zip the length of the hood. Secure the sides of
the accessory to the stroller frame match up the snaps with
the corresponding snap mates on the underside of the stroller
frame and snap into place.
47. To secure the foot of the accessory to the stroller, pull the
elastic foot over the end of the stroller, and use the snaps
on the foot tabs to snap to the corresponding snap mates on
underside of the stroller frame.
seaT PaD aND INFaNT HeaDHUGGeR
FIGURE S
48. Your stroller is equipped with a removable ‘seat pad with
infant head hugger’ and shoulder harness covers. The head
hugger is designed to optimise the comfort of newborn babies
within the stroller. The Universal Head Hugger comes in two
parts: the seat pad and the infant head hugger. The infant
head hugger fits snuggly into the seat pad.
49. Make sure the Harness is unfastened. Place seat pad into
stroller. Thread the Harness buckle through the opening in the
seat pad. Release the Velcro fastening at the shoulder of the
seat pad. Pass the shoulder harness strap to the front of the
seat pad and reseal the Velcro. Repeat for other side. Position
the infant head hugger. Release the Velcro fastening at the
shoulder of the infant head hugger. Pass the shoulder harness
strap to the front and reseal the Velcro. Repeat for other side.
If required, adjust length of the harness so it fits snuggly but
not too tightly to child. To avoid damage to clothes, check that
all Velcro has been fastened and covered completely by the
pads. As your infant grows, remove the infant head hugger
when no longer needed by reversing the process.
Seat Pad
Infant
Hugger
R
S
Q
