assembly
FIGURE A
1. Remove the stroller from the carton and dispose
of all packaging thoughtfully
including the black
rubber protectors on either side of the brake bar
and front wheel protector.
The front wheel forks,
rear wheels, front bar and hood all need to be
installed prior to use.
2. Lay the stroller flat on the floor and carefully cut
any cable ties which hold the frame.
3. Lift the handle upward to a vertical position.
FIGURE B
4. Lift the front wheel housing upward so that the
stroller frame unfolds from beneath.
5. Press down on the basket side locking
hinge with your hand or foot.
6. Secure the frame closed by swinging the
fold latches (located on both sides of the
frame) and fully engaging them tightly onto
the frame.
I
MPORTANT WARNING: ALWAYS TEST
THAT ALL LATCHES ARE SECURELY
ENGAGED BEFORE USE.
ReaR WHeels
FIGURE C
7. Pressing on it’s centre hub button, insert the
Super Quick Release (SQR) axle through the
outside of the metal hub in each wheel.
IMPORTANT : INSERT THROUGH THE OUTSIDE OF
THE WHEEL, THE SIDE WHICH DOES NOT HAVE
THE BLACK BRAKE COG
8. Continue pressing the hub button and insert the
protruding long axle into the tube opening at the
rear of the stroller chassis; repeat this step for the
other side.
FIGURE D
9. To remove the wheel simply press the button in
the centre of the wheel hub and simultaneously
pull the wheel outward.
If your brakes do not engage, check to see that the nylon
brake cogs are on the INSIDE of each wheel when it is
attached to the chassis. If not, remove the wheel and
SQR axle and re-insert the SQR axle from the other side
of the wheel, so that the cog will be on the inside of the
wheel.
9
A
B
C
D
PRESS
