M007502200
12/07/2007
MELTON, S.L. - POLIGONO INDUSTRIAL AGUSTINOS CALLE G-34,31160 ORCOYEN, NAVARRA
TEL: 00 34 948 321580 Fax: 00 34 948 326584 e-mail:[email protected] http://www.melton.es
15
* Alloctation ftcs *
Ftc for channel x: X
Where X is the number of the photocell that will give the start signal to
that channel. If this parameter is set to 0 the channel is disabled.
Minimum speed:
* Configuration *
-- Minimun speed
Press
to enter the menu or
Esc
to exit.
The display will show:
* minimum speed *
Vmin.: xxx m/min
Where XXX is the minimum speed at which the pattern control has to
work. When the line speed is below the programmed value, the control
disables all the programming automatically.
Cycle selection:
This control only works if mould type = 1.
* Configuration *
-- Close Cycle
Press
to enter the menu or
Esc
to exit.
The display will show:
* Close Cycle *
By FTC Signal
When FTC Signal is ON the control finish with the photocell.
Use the arrows
to change the selection.
The display will show:
* Close Cycle *
By Pattern ended
Press
to choose the selection. In this way The CP-40 finish all cycle.
