VALBERG 972331, Инструкция по эксплуатации

Страница: 9 / 128

14 15 FR FR
Utilisation de l’appareil Utilisation de l’appareil
B B
14 15 EN EN
Using the appliance Using the appliance
B B
NOTE : Depending on the location of your electrical socket,
it may be necessary to make an opening in the opposite
side of the cabinet.
Step 2: Dimensions and installation of the front
NOTE : The wooden front must be installed according to
the installation diagrams.
• Fully integrated model
Install the hook on the wooden front and insert the hook into the slot in the outer door of
the dishwasher (see figure A ). After positioning the front panel, fix it to the outer door with
screws and bolts (see figure B ).
A
B
2. Install the four long screws
1. Remove the four short screws
Step 3: Adjusting the door spring tension
1. The door springs are preset to the correct tension for the outer door. If you are installing
a wooden front, you will need to adjust the tension of the door springs. Turn the adjusting
screw to move the tensioner and tighten or loosen the wire cable.
2. The tension of the door springs is correct when the door remains horizontal in the fully
open position, but rises to the closed position at the touch of a finger.
Step 4: Dishwasher installation steps
NOTE : Please refer to the installation steps described in
the corresponding diagrams.
1. Attach the condensation strip to the underside of the cabinet worktop. Ensure that the
condensation strip is aligned with the edge of the worktop. (Step 2)
2. Connect the supply hose to the cold water inlet.
3. Connect the drain hose.
4. Connect the power cable.
5. Position the dishwasher. (Step 4)
6. Level the dishwasher. The rear leg can be adjusted from the front of the dishwasher by
turning the cross screw in the middle of the dishwasher base, using a cross slot screwdriver.
To adjust the front feet, use a flat screwdriver and turn the front feet until the dishwasher is
level. (Steps 5 to 6)
7. Fit the cabinet door to the outer door of the dishwasher. (Steps 7 to 10)
8. Adjust the tension of the door springs with a hex key, turning it clockwise to tighten
the door springs on the left and right sides. Failure to do so may result in damage to your
dishwasher. (Step 11)
9. The dishwasher must be securely fixed in place. This can be done in two ways:
C . Standard worktop: Place the installation hook into the notch in the side panel and secure
it to the worktop with wood screws.
D . Marble or granite worktops: fix the side with screws.