Vaillant VRC 430 Operating and, Руководство по эксплуатации и установке

Страница: 27 / 40

7 Installation instructions VRC 430
1
2
3
4
3
5
4
Fig. 4.2 Installation of the VRC 693 outside sensor
Key
1 Cover for the enclosure
2 Wall
socket
3 Cap nut for cable entry point
4 Connection cable with drip loop
5 Mounting
apertures
Fig. 4.3 Installation of the VRC 9535 outside sensor
Key
1 Cover for the enclosure
2 Wall
socket
3 Cap nut for cable entry point
4 Connection cable with drip loop
5 Mounting
apertures
This is how to do it:
⇒
Mark the position on the wall. Observe the cable
routing for the outside sensor.
⇒
Route the connection cable ( 4 ) with a slight incline
to the outside and with a drip loop.
⇒
Remove the cover from the enclosure ( 1 ) of the
outside sensor.
⇒
Drill two holes 6 mm diameter to suit the fixing
apertures ( 5 ).
⇒
Insert the plugs supplied.
⇒
Fix the wall socket ( 2 ) to the wall with 2 screws. The
cable entry must point downwards.
⇒
Release the cap nut ( 3 ) slightly and push the
connection cable through the cable entry from
below.
⇒
The electrical installation as described in Chapter
5.2 for the VRC 693, and in Chapter 5.3 for the
VRC 9535.
⇒
Re-tighten the cap nut ( 3 ). The packing in the cable
entry adapts to the diameter of the cable used
(Cable diameter: 4.5 to 10 mm).
⇒
Carefully push the cover for the enclosure onto the
wall socket until it clicks in position. Do not forget
the seal between the wall socket and the cover for
the enclosure.
Assembly 4