VAI 6 WN-I_EN - 06/14 - Vaillant
3
1 Your safety
1.1
Symbols used
a
DANGER!
• Direct danger for life and health
.
e
DANGER!
• Danger electric shock
.
b
WARNING!
• Potentially dangerous situation for the product
and the environment
.
i
NOTE!
Useful information and indications
.
1.2
Correct use of the unit
This unit has been designed and manufactured for the sole
purpose of providing cooling and heating in occupied residential
and commercial premises. The use thereof for other domestic
or industrial purposes shall be the exclusive responsibility of the
persons specifying, installing or using them in that way
.
Prior to handling, installing, start up, using or performing
maintenance on the unit, the persons assigned to perform
these tasks should be familiar with all the instructions and
recommendations set forth in the unit’s installation manual
.
i
Keep the manuals throughout the service life of
the unit.
i
The information relating to this unit is divided bet�
The information relating to this unit is divided bet
-
ween two manuals: installation manual and user
manual.
i
This equipment contains R�410A refrigerant. Do
not vent R�410A into atmosphere: R�410A, is a
fluorinated greenhouse gas, covered by Kyoto
Protocol, with a Global Warming Potential (GWP)
= 1975.
i
The refrigerant fluid contained in this equipment
must be properly recovered for recycling, recla
-
mation or destruction before the final disposal of
the equipment
.
i
The relevant personnel performing any service of
maintenance operations involving the handling of
the refrigerant fluid must have the necessary cer
-
tification to comply with all local and international
regulations
.
2 Extreme operating conditions
This unit has been designed to operate within the range of
temperatures indicated on Figure 2.1. Ensure that these
ranges are not exceeded
.
Model
Cooling (ºC)
Heating (ºC)
Indoor
low
Outdoor
low
Outdoor
high
Indoor
high
Outdoor
low
Outdoor
high
VAI 6-025 WN
16
-7
45
30
-7
24
VAI 6-035 WN
16
-7
45
30
-7
24
VAI 6-050 WN
16
-7
45
30
-7
24
VAI 6-065 WN
16
-7
45
30
-7
24
Table 2.1
Operating ranges of the unit
.
The working capacity of the unit changes depending on the
working temperature of the outdoor unit
.
3
Identification of the unit
This manual is valid for the Split system series. In order to
know the specific model of your unit please refer to the unit
nameplates
.
The nameplates are located on the outdoor and indoor units
.
4 Declaration of conformity
The manufacturer declares that this unit has been designed
and constructed in compliance with the standard in force with
regard to obtaining the CE Marking
.
The appliance type satisfy the essential requirements of the
relevant directives and Standards:
• 2006/95/EEC including amendments:
”
Directive on the harmonisation of the laws of Member States
relating to electrical equipment designed for use within
certain voltage limits
“
Designed and built according to European Standards:
- EN 60335-1
- EN 60335-2-40
- EN 50366
EN
INTRODUCTION
