Vaillant EIWH electronicVED E 9/1-B IN, Инструкции по эксплуатации и монтажу

Страница: 5 / 12

eletronicVED pro series
5
Notes on the documentation 2
Caution�
Kindly remind�
▶ Water inside water heater is forbindden to be
drunken.
1 Heater strip
2 Heater upper cover
3 Temperature controller
4 Water resistence detection
5 Lower casing
6 Housed controlled silicon
7 Outlet water temperature
sensor
8 Inlet water temperature
sensor
1 Temperature controller
2 Heating body
3 Control panel
4 Display board
9 Heater
10 Heater low cover
11 Outlet pipe
12 Wiring board
13 Circuit board
14 Water adjust valve
module
15 Flow sensor
16 Inlet pipe
5 Temperature sensor
6 Flow sensor
7 Water resistence detection
Appliance type
VED E 9/1-B IN
2 Notes on the documentation
The following description is a general guide covering the
entire document.
Other information must be used in conjunc-tion with this
operation and installation instructions.
We do not undertake any liability for damage caused by
non-compliance with these instructions.
Reference
When operating the water heater, be sure to notice all the
operating instructions attached to the other components of
the appliance.
These instructions are attached to the corresponding
appliance components.
2�1 Information storage
▶ Transfer necessary auxiliary tools to the appliance users.
▶ Users are responsible for keeping them in order to use
instructions and auxiliary tools as required.
2�2 Scope of the instructions
This instructions are only applicable to appliance with the
following types:
Table 2.1 Appliance and type name
The types of the appliance please refer to the nameplates.
2�3 Appliance type
The type of appliance to install can be determined according
to technical data of the installation instructions.
3 Product features and use
The water heater includes low water resistance protection,
high temperature protection, dry burning protection, and
safety earth protection functions.
When the appliance is switched on, the inlet water
resistance will be detected. When the water resistance does
not meet the requirements, the appliance will be stopped,
and will display E7.
4 Appliance structure and technical
parameters
4�1 Appliance structure
Fig.4.1 Appliance structure
Remark
4�2 Electrical schematic diagram
Fig 4.2 electrical schematic diagram
Remark