5 Installation
14
Installation and maintenance instructions ecoVIT exclusiv 0020258610_00
▶
Only connect the power supply cable to
the terminals marked for the purpose.
1.
Route the connection cables of the components to be
connected through the grommet to the electronics box.
2.
Use the strain reliefs provided.
3.
Shorten the connection cables as necessary.
4.
To prevent short circuits if a strand accidentally comes
loose, only strip the outer sheathing of flexible lines to a
maximum of 30 mm.
5.
Ensure the inner conductor insulation is not damaged
when stripping the outer sheathing.
6.
Only strip inner conductors just enough to establish
good, sound connections.
7.
To avoid short circuits resulting from loose individual
wires, fit conductor end sleeves on the stripped ends of
the conductors.
8.
Screw the respective plug to the connection cable.
9.
Check whether all conductors are sitting mechanically
securely in the terminals of the plug. Remedy this if
necessary.
10. Plug the plug into the associated PCB slot.
11. Use the strain reliefs to secure the cable in the elec-
tronics box.
5.9.3
Establishing the power supply
Caution.
Risk of material damage due to high con-
nected voltage.
At mains voltages greater than 253 V, elec-
tronic components may be damaged.
▶
Make sure that the rated voltage of the
mains is 220 V.
Caution.
Risk of malfunctions due to line interrup-
tion and signal interference.
If there is insufficient strain relief, electrical
contacts may be loosened. Power supply
cables may cause faults in signal-carrying
cables.
▶
Do not use the same strain relief for the
low-voltage cable as for the power supply
cable.
9
8
7
+
-
5
4
3
N
L
BUS
9
8
7
+
-
5
4
3
N
L
BUS
1.
Observe all valid regulations.
2.
Open the electronics box. (
→
Page 13)
3.
Connect the product using a fixed connection and a
partition with a contact gap of at least 3 mm (e.g. fuses
or power switches).
4.
Use a flexible line for the power supply cable, which is
routed through the grommet into the product.
5.
Route the power supply cable to the connection level in
the electronics box, as shown.
6.
Wire the cables. (
→
Page 13)
7.
Screw the turquoise plug, which is installed in the right
of the electronics box, to a suitable, flexible, three-core
power supply cable that complies with the relevant
standards.
8.
Connect the plug to the slot of the same colour on the
PCB.
9.
Close the electronics box. (
→
Page 13)
10. Ensure that access to the partition is always available,
and that it is not covered or blocked.
