18
1
Shower inoperable,
no water flow.
1.1
Cover incorrectly
fitted/out of
alignment.
1.1.1
Check cover and remove and refit if not
aligned/seated correctly.
1.2
No mains water
supply to shower.
1.2.1
Check if isolating valves are fully open. Check
for a blockage in inlet filter or in pipework.
1.3
Unit malfunction.
1.3.1
Have unit checked. Ring Customer Service.
2
Water too hot.
2.1
Not enough water
flowing through the
shower.
2.1.1
Increase flow rate via temperature control.
2.1.2
Blocked showerhead — clean or replace
blocked sprayplate in showerhead.
2.2
Blockage in supply.
2.2.1
Check if stop valves are fully open.
Check if a blockage in the inlet filter.
2.3
Increase in ambient
water temperature.
2.3.1
Readjust flow rate to give increased flow.
2.3.2
Set the ‘Mode Select Switch’ to number 2.
3
Water temperature
cycling hot/cool at
intervals.
3.1
Heater cycling on
thermal cut-out.
3.1.1
See
‘Water too hot’
causes 2.1, 2.2 and 2.3 and
their appropriate action/cures. If it continues,
contact Customer Service.
4
Water too cool
or cold.
4.1
Too much flow.
4.1.1
Reduce flow rate via temperature control.
4.2
Water pressure below
minimum required
(see rating label).
4.2.1
Is water supply mains or tank fed?
4.2.2
If tank fed, replumb to mains water supply or
see 4.2.4.
4.2.3
If mains fed, make sure that mains stopvalve
is fully open and that there are no other
restrictions in the supply while shower is in use,
or
see 4.2.4.
4.2.4
Fit pump to give minimum pressure
(see rating
label)
. Contact Customer Service for advice.
FAULT FINDING/TROUBLESHOOTING
Problem/Symptom
Cause
Action/Cure
FAULT FINDING
Important:
Switch off the electricity at the mains supply and remove the circuit fuse before
attempting any fault finding inside the unit.
Problem/Symptom Cause
Action/Cure
Содержание BLACK CHIC
Страница 25: ...21 ...