9
Installation
- FIT TO THE WALL & CONNECT THE SHOWER SUPPLIES
Fig.9
PLEASE NOTE:
NONE
of the 'cut outs' are designed to 'snap out'.
ONLY
a junior hacksaw or suitable
knife should be used. Excessive damage to the cover may invalidate product specifications and warranty.
ELECTRICAL INSTALLATION
IMPORTANT:
Switch off the electricity supply at
the mains before proceeding.
• The supply cable
MUST
be secured either by
routing through conduit, in trunking, or by
embedding in the wall, in accordance with
IEE regulations.
NOTE:
Conduit entry can only be from rear.
Installation
- ELECTRICAL INSTALLATION
NOTE:
Deviations from the designated entry
points will invalidate product approvals. The
cable entry points are listed on
page 3
.
• Seal around rear entry cable to prevent water
ingress into the wall.
FIT TO THE WALL & CONNECT THE
SHOWER SUPPLIES
Please see
page 3
(fig.2)
for specified inlet points.
•
(fig.9) -
Numbers
1
,
2
and
3
are removable
water pipe entry trims. Number
4
and
5
are
‘cut out’ water pipe entry points.
•
(fig.9) -
Number
6
is the bottom ‘cut out’
electrical cable entry point. This should be
used if water and electricity are entering at
that point.
•
(fig.9) -
Number
7
is the top ‘cut out’
electrical entry point that should be used if
both water and electricity are entering from
the top.
NOTE:
If top or bottom electrical entry is chosen
with no water entry at that point, the pipe trim
entry may be used. The removable trim should
be cut to the shape of the incoming sheathing
to minimise water ingress.
Fitting Procedure
• Turn off water supply either at the mains
stopvalve or the isolating stopvalve.
• Using the chosen 15mm x 15mm
compression fitting without olives or nuts
in place, present the shower with the
compression fitting on the inlet to the
incoming water supply. This is to establish the
position of the backplate mounting holes.
6
check list
7
check list
SECTION
SECTION
Front of
the cover
7
6
3
2
1
4
5
Содержание BLACK CHIC
Страница 25: ...21 ...
