programming instructions
"Sealing" light will flash, the seal wire will work, and the LED display will begin
to count backwards by 0.5 seconds. After "Sealing", it enters "Cooling" mode.
The "Cooling" light will flash and the LED display will begin to count backwards
by 0.5 second. After "Cooling", the releasing valve will function, and the
operation will be completed.
10 . "Vacuum Marinate" Mode
- In "Vacuum Marinate" mode, close the lid and
the "Marinate" light will flash. It takes nine minutes for a work cycle, including
vacuuming, maintaining the vacuum, and releasing. After the work cycle, the
machine enters the "Vacuum" machine mode (the same as #8), and the LED
display will begin to count down. With 1 second to the end, the pump will stop
working and the LED display will display the marinate time. The decimal point
flashes and the countdown starts. After 8 minutes, the machine releases the air,
starts the cycle, and continues to marinate until the marinate time countdown
hits zero. At that point, the operation is completed.
11 . Cancel the Sealing/Cooling Operation
- Press the "Stop" button to stop the
operation and release the air while the machine is in the "Sealing/Cooling" mode.
12 . Cancel the Gas/Sealing/Cooling Operation
- Press the "Stop" button to stop the
operation and release the air while the machine is in the "Gas/Sealing/Cooling"
mode.
13 . Machine Alarm Function
- E01: When the machine enters the "Sealing"
process, the vacuum lid is not closed for protection (the door control switch is
not triggered to close); LP: When the machine is running, press the "Stop"
button to exit and release.
14 . Memory Function
- The machine will remember the last parameter setting
after power off.
15 . Resume Factory Settings
- Before the machine is powered on, press the "Set"
and "Up" buttons for 3 seconds at the same time. The machine will display "rS"
for resume. At this point factory settings will be reset.
7
