Vacon 100 INDUSTRIAL, Инструкция по установке и эксплуатации

Страница: 20 / 47

Programming vacon • 18
24-hour s358 (0)40 837 1150 • Email: vacon@vacon.com
5
5.2 Modbus TCP parameters and monitoring values
5.2.1 Ethernet common settings (M5.8.1)
Table 5. Common settings for Modbus TCP (Ethernet)
5.2.2 Modbus TCP settings (M5.8.2)
Table 6. Parameters related with BACnet used through Ethernet
Code Parameter Min Max Unit Default ID Description
P5.8.1.1 IP address mode See page 21.
P5.8.1.2 IP address See page 21.
P5.8.1.3 Subnet mask See page 21.
P5.8.1.4 Default gateway See page 21.
P5.8.1.5 MAC address See page 21.
Code Parameter Min Max Unit Default ID Description
PARAMETERS (Common settings M5.8.2.1)
P5.8.2.1.1 Connection limit 0 2 2
Number of allowed con-
nections
P5.8.2.1.2
Unit identifier num-
ber
0 255 1
See chapter 5.4.2 Mod-
bus TCP settings
P5.8.2.1.3
Communication
time-out
0 65535 s 0 0 = Not used
MONITORING VALUES (Connection 1, Monitoring M5.8.2.2.1)
*
* Will appear only after connection has been established
P5.8.2.2.1.1
Fieldbus protocol
status
1 3
1 = Stopped
2 = Operational
3 = Faulted
P5.8.2.2.1.2
Communication
status
0.0 99.999 0.0
0-99 Number of mes-
sages with errors
0-999 Number of mes-
sages without communi-
cation errors
P5.8.2.2.1.3 Illegal functions 0 See page 23.
P5.8.2.2.1.4
Illegal data
addresses
0 See page 23.
P5.8.2.2.1.5 Illegal data values 0 See page 23.
P5.8.2.2.1.6 Slave device busy 0 See page 23.
P5.8.2.2.1.7 Memory parity error 0 See page 23.
P5.8.2.2.1.8 Slave device failure 0 See page 24.
P5.8.2.2.1.9 Last fault response 0 See page 24.
P5.8.2.2.1.10 Control word hex See page 29.
P5.8.2.2.1.11 Status word hex See page 31.
MONITORING VALUES (Connection 2, Monitoring M5.8.2.3.1)*
All parameters are the same as those for Connection 1.