Vacmaster VBVA1010PF, Руководство оператора

Страница: 14 / 32

14
INSTALLING & CLEANING
FOAM WET FILTER
Installing Foam Wet Filter
1. Verify that the power cord is disconnected from the outlet. (Fig. 1)
2. Remove power head and place in upside down position. Follow instructions to remove cartridge
filter.
3. Carefully slide foam wet filter down over the filter cage making sure the cage is completely
covered. (Fig. 2 & 3)
4. Place the power head onto the collection tank.
Cleaning Foam Wet Filter
1. With the removed power head in an upside down position, carefully remove foam wet filter. (Fig.
4)
2. Use a mild soap and water solution to wash foam wet filter and rinse with clean water. (Fig. 5)
3. Allow filter to air dry before installing and using again.
1 2 3 4 5
TROUBLESHOOTING
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK, UNPLUG BEFORE
TROUBLESHOOTING.
Symptom Possible Causes Corrective Action
Vacuum will not operate
1) No power supply. 1) Check power supply – cord,
breakers, fuses.
2) Faulty power cord. 2) Unplug and check the
power cord. If damaged,
have it repaired by a
professional.
3) Collection tank full. 3) Empty collection tank.
4) Switch in the wrong position. 4) Press the ON ‘I’ button on
the power head.
Dust comes from motor cover. 1) The cartridge filter is
missing or damaged.
1) Attach or replace the
cartridge filter.
Reduced efficiency and motor/
speed vibration.
1) There is a blockage in the
nozzle or hose, or the
collection tank inlet. Or dust
filter blocked by fine dust.
1) Take off the filter and clean it
or install a new cartridge
filter.