Vacmaster VBVA1010PF, Руководство оператора

Страница: 8 / 32

8
LIQUID VACUUM OPERATION
LIQUID VACUUMING
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY, INFORMATION
ENTITLED ‘SAFETY INSTRUCTIONS & WARNINGS’. DO NOT VACUUM IN AREAS WITH
FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE
GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT
TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS.
EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN,
OR GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR
DUST, DO NOT VACUUM TOXIC MATERIALS.
WARNING:
DO NOT PLUG POWER CORD INTO POWER OUTLET. MAKE SURE PLUG
IS DISCONNECTED BEFORE CHANGING THE FILTERS.
2
4
5 1 3
1. Verify that the power cord is disconnected from the outlet. (Fig. 1)
2. Remove cartridge filter, then carefully install the foam wet filter over the filter cage and place the
power head back on the collection tank. For filter installation instructions, see page 14.
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.
OPERATING INSTRUCTIONS: WET VACUUMING
3. Fit the desired nozzle to the vacuum hose. (Fig. 2)
4. Verify that the power switch is in the ‘O’ OFF position before plugging the power cord into the
outlet. (Fig. 3)
5. Turn the motor on by pressing the switch to the ‘I’ ON position. (Fig. 4)
6. Once you have completed vacuuming, press the power switch to the 'O' (OFF) position and
unplug the power cord from the outlet.
7. After use, empty the collection tank by unscrewing the drain cap and drain liquids into suitable
receptacle or drain. (Fig. 5) Remember to refit the drain cap to the tank.
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely
in the liquid; leave a gap at the tip of the nozzle opening to allow air inflow. The machine is fitted
with a float valve that stops the suction action when the collection tank reaches its maximum
capacity. You will notice an increase in motor speed. When this happens, turn off the machine,
disconnect from power supply, and drain the liquid into a suitable receptacle or drain. After wet
vacuuming, turn the machine off and remove plug from power supply. Empty the collection tank,
clean and dry the inside and outside before storage. REMEMBER! The foam wet filter must be
removed after wet vacuuming, and a cartridge filter must be installed before dry vacuuming again.