![background image](http://html2.mh-extra.com/html/v-zug/winecooler-v6000/winecooler-v6000_operating-instructions-manual_3228876040.webp)
EN-10
Storage diagram
Presentation shelf
Cleaning
A failure to follow these instructions may result in the food being
spoilt.
WARNING
Before cleaning, always disconnect the appliance
from the mains. Pull out the plug or switch off the
fuse.
Surfaces which may come into contact with food
and accessible drain systems must be cleaned at
regular intervals.
If the door is left open for a lengthy period, the
temperature in the appliance's compartments may
rise dramatically.
• Clean the inside, equipment parts and outer walls with lukewarm
water and a little detergent. Do not use chemical solvents or any
cleaning agents containing sand or acid.
• Use a glass cleaner to clean the glass surfaces and a commercially
available stainless-steel cleaning agent for the stainless-steel
surfaces.
CAUTION
Risk of damage to the appliance components and
risk of injury due to hot steam.
Do not use steam cleaning equipment to clean
the appliance.
• Ensure that no cleaning water penetrates into the electrical
components or ventilation grille.
• Dry all parts well with a cloth.
• Do not damage or remove the type plate on the inside of the
appliance. It is very important for servicing purposes.
If the appliance is left empty for a lengthy period, it must be
switched off, defrosted, cleaned and dried and the door is to be
left open to prevent mould formation.
Trouble-shooting
•
F0, F1, E1, E2, E7 or E8 appears in the display.
– The appliance has suffered a fault. Contact the customer service
department.
•
The fans inside the appliance are running although the
fan function has been deactivated and the compressor
(refrigeration unit) is idle.
– This is a normal operating state depending on the set interior
temperature and ambient temperature at the place of installation.
You may be able to rectify the following faults by checking
the possible causes yourself.
• Appliance does not function:
– Is the appliance switched on?
– Is the plug correctly fitted in the mains socket?
– Is the fuse intact?
•
When inserting the mains plug, the refrigeration unit does
not switch on, but a value is shown in the temperature
display.
– Demo mode is activated. Contact the customer service depart-
ment.
• Loud running noise:
– Is the appliance set up firmly on the floor?
– Does the appliance cause nearby items of furniture or objects to
vibrate? Please note that noises caused by the refrigerant circuit
cannot be avoided.
– Due to the various speed steps, speed-regulated compressors
can generate different running noises.
The sound is normal.
• The temperature is not low enough:
– Is the temperature setting correct (see "Setting the temperature")?
– Does the separately installed thermometer show the correct
reading?
– Is the ventilation system working properly?
– Is the appliance set up too close to a heat source?
• The compressor runs for a long time.
– The compressor switches to a low speed when little cold is needed.
Although the running time is increased as a result, energy is saved.
This is normal in energy-saving models.
• A low hum.
– The sound is produced by air flow noise of the fan.
The sound is normal.
• The internal light does not come on.
– The appliance is not switched on.
Switch the appliance on.
– The door was open for longer than 15 minutes.
The internal light switches itself off automatically after about 15
minutes if the door is open.
– The LED illumination is faulty or the cover is damaged.