V-ZUG V600 8UN, Руководство по эксплуатации

Страница: 42 / 48

Defect Cause Remedy
Excessive noise.
→ Due to the various speed steps,
speed-regulated* compressors can
generate different running noises.
u
The sound is normal.
A bubbling and
gurgling noise.
→ This noise comes from the refrig‐
erant flowing in the refrigeration
circuit.
u The sound is normal.
A quiet clicking
noise.
→ The noise is produced whenever
the refrigeration unit (motor) auto‐
matically switches on or off.
u The sound is normal.
A hum. It is briefly
a little louder
when the refrig‐
eration unit (the
motor) switches
on.
→ Refrigeration increases automati‐
cally when the Fast-Freeze func‐
tion is activated, fresh food has
just been placed in the appliance
or the door has been left open for a
while.
u This noise is normal.
→ The ambient temperature is too
high.
u Solution: (see 1.2 Appliance range of use)
A low hum.
→ The sound is produced by air flow
noise of the fan.
u The sound is normal.
Vibration noises
→ The appliance is not standing
firmly on the floor. As a result
objects and adjacent units start
to vibrate when the refrigerator is
running.
u Check the installation and realign the appliance.
Flow sound at the
soft stop mecha‐
nism.
→ The noise is produced when the
door is opened and closed.
u The sound is normal.
The temperature
display indicates:
F0
to
F9
*
→ There is a fault. u Please contact the after-sales service (see 6 Mainte‐
nance) .
Power failure
flashes in
the temperature
display . The
highest tempera‐
ture reached
during power
failure is indicated
in the temperature
display.
→ The freezer temperature rose too
high over the last hours or days
due to a power failure or power
interruption. When the power inter‐
ruption is over, the appliance will
continue to operate in the last
temperature setting.
u To cancel the display of the warmest temperature: press
alarm button Fig. 2 (6).
u Check the quality of the food. Do not consume spoiled
food. Do not re-freeze thawed food.
DEMO shines in
the temperature
display.
→ The demo mode is activated.
u
Please contact the after-sales service (see 6 Mainte‐
nance) .
The outer surfaces
of the appliance
are warm*.
→ The heat of the refrigeration circuit
is used to prevent condensate from
forming.
u This is normal.
The temperature is
not cold enough.
→ The door of the appliance is not
properly closed.
u
Close the door of the appliance.
→ Insufficient ventilation. u Keep ventilation grille clear, and clean it.
→ The ambient temperature is too
high.
u Solution: (see 1.2 Appliance range of use) .
→ The appliance was opened too
frequently or for too long.
u Wait to see whether the appliance reaches the required
temperature by itself. If not, please contact the after
sales service (see 6 Maintenance) .
Malfunctions
42 * Depending on model and options