V-ZUG UnimaticDry V2000, Руководство по эксплуатации

Страница: 7 / 44

1 Safety warnings
7
Caution: Risk of burns!
▪ Do not dry fabrics that contain traces of
hair spray, hair gel, nail varnish remover
or other similar substances. Danger of
gas build-up!
Caution: Risk to life!
▪ Packaging material, e.g. plastic film and
polystyrene, can be dangerous for chil-
dren and animals. Danger of suffoca-
tion! Keep packaging material away
from children and animals.
▪ When carrying out maintenance work
on the appliance, including replacing
light bulbs, cut off the electricity supply
to the appliance: remove the screw fuse
from the holder or switch the circuit
breaker off, or unplug from the mains
socket.
How to avoid damaging the appliance
▪ Close the appliance door carefully.
▪ When cleaning the appliance make
sure no water gets inside it. Use a mod-
erately damp cloth. Do not spray the
outside or the inside of the appliance
with water. If water gets inside the appli-
ance, it will cause damage.
Room conditions/Ventilation
▪ WARNING: If the size of the room is
<10 m
2
(<20 m
3
), it needs to be ventil-
ated. There must be air inlet and outlet
openings to the adjacent room or to the
outside, e.g. open window/door, ventila-
tion grille or slits in the door or ventila-
tion system.
▪ For all room sizes: Regularly ventilate
the room where the tumble dryer
stands.
▪ As a general rule, rooms containing
heat pump dryers should be ventilated
as these produce a small amount of
moisture. If the room is kept closed, it
must be aired occasionally (either by
opening the door to the room or a win-
dow) between several consecutive dry-
ing programmes.
Transport and installation
Fron
t
Front
Tilt max. 90° to the left!
▪ Transport the appliance in an upright
position only! Transporting it in any
other position will result in damage to
the appliance! When carried carefully
without being shaken, the appliance
may be tilted a maximum of 90° to the
left (viewed from the front).
▪ If the location of the appliance is
changed, because of the heat pump it
must stand in its final position for
around 2 hours before it can be oper-
ated again. Failure to do this can result
in damage to the appliance.