V-ZUG Jumbo 60i, Руководство по эксплуатации

Страница: 35 / 44

5.1.1 Setting the child lock function
u
To activate setting mode: Press and hold the SuperCool
button Fig. 2 (2) for approx. 5 s.
w
The display indicates
c
.
When
c1
is shown on the display:
u
To switch on the child-proof lock, press the
SuperCool button
Fig. 2 (2) briefly.
w
The child lock symbol
Fig. 2 (8) shines. c
flashes in the
display.
When
c0
is shown on the display:
u
To switch off the child-proof lock, press the SuperCool
button
Fig. 2 (2) briefly.
w
The child lock symbol
Fig. 2 (8) goes out. c
flashes in the
display.
u
To deactivate the set-up mode: press On/Off button
Fig. 2 (1).
-or-
u
Wait for 5 minutes.
w
The temperature is indicated again in the temperature
display.
5.2 Door alarm
An audible warning sounds if the door is open for longer
than 60 seconds.
The audible warning stops automatically when the door
is closed.
5.2.1 Muting the door alarm
The audible alarm can be muted when the door is open. The
sound switch-off function is active as long as the door is left
open.
u
Press alarm button Fig. 2 (5).
w
The door alarm is silenced.
5.3 Refrigerator compartment
Different temperature ranges are set in the fridge compartment
because of the natural air circulation. It is coldest directly above
the plate dividing the FreshControl area and the rear wall. The
warmest area is at the top front and in the door.
5.3.1 Food refrigeration
u
Place butter and preserves in the upper area and in the door
(see Appliance at a glance).
u
Use recyclable plastic, metal, aluminium and glass
containers and cling film for wrapping.
u
Always store liquids and food which is subject to odour or
taste transfer in closed containers or cover them.
u
Use the front area of the refrigerator compartment floor only
for briefly putting down cooled products, e.g. when rear-
ranging and sorting. However do not leave cooled products
there otherwise they may be pushed back or tipped over
when the door is closed.
u
Do not store food too close together to enable good air
circulation.
5.3.2 Setting the temperature
The temperature depends on the following factors:
-
the frequency of opening the door
- the room temperature of the installation location
- the type, temperature and quantity of the food
The temperature can be set from 9 °C to 3 °C, the recom-
mended temperature is 5 °C.
An average temperature of about –18 °C is reached in the
freezer compartment.
Note
If the temperature is to be colder than 3 °C:
u
set the cooling temperature to 3 °C.
u Set the FreshControl temperature to a value between b4
(slightly colder) and b1 (coldest) (see 5.4)
u
For a higher temperature setting: press Up button
Fig. 2 (3).
u
For a lower temperature setting: press Down button
Fig. 2 (4).
w
When the button is pressed the first time, the previously set
value is indicated, flashing, in the temperature display.
u
To change the temperature in 1 °C steps: briefly press the
button.
u
To change the temperature continuously: hold down the
button.
w
The value is displayed flashing during the setting operation.
w
The actual temperature is displayed about 5 s after the last
press of a button. The temperature slowly adjusts to the new
value.
5.3.3 Quick Cool
Quick Cool selects the lowest cooling temperature. This
gives you colder storage temperatures. Use Quick Cool
to quickly cool large quantities of food.
Quick Cool uses slightly more energy.
Cool with Quick Cool
u
Briefly press the Quick Cool button
Fig. 2 (2).
w
The Quick Cool Fig. 2 (9) symbol lights up on the display.
w
The cooling temperature drops to the lowest setting.
Quick Cool is on.
w
Quick Cool switches off automatically after 12 hours. The
appliance continues in energy-saving Normal mode.
SwitchingQuick Cool off ahead of schedule
u
Briefly press the Quick Cool button
Fig. 2 (2).
w
The Quick Cool
Fig. 2 (9) symbol dims on the display.
w
Quick Cool is off.
5.3.4 Shelves
Moving or removing shelves
The shelves are prevented from being pulled out accidentally
by pull out stops.
Fig. 3
u
Lift the shelf and pull forward a little.
u
Adjust the height of the shelf. To do this move the slots along
the supports.
u
In order to remove the shelf fully, place it at a slant and pull
out towards the front.
u
Re-insert shelves at the required height. The stops must
face downwards and lie behind the front shelves.
Control
* Depending on model and options 35