Installation instructions
Built-in variants of gas hob
Multi-sliders GAS411/421
1009436-R07
22/02/2018
1009436-R07
7
Thread length
The thread length of the gas connection on the appliance (external thread)
So
is 12 mm. If the
thread length of the on-site counterpart (internal thread)
Si
is longer than 13 mm, the front-end seal
is no longer guaranteed through the supplied green sealing ring H64006 with a height of 1.5 mm.
In this case, the yellow sealing ring 1030096 with a height
h
of 5 mm is to be used as it provides a
leak tight connection for on-site thread lengths of up to 16.5 mm.
Si
So
h
½-inch conical thread
If the gas connection has a conical thread, the transition piece and sealing ring must first be
screwed onto the appliance. The transition piece has a conical external thread R ½-inch in accord-
ance with ISO 7/11. In the case of a conical screw connection, the thread makes the seal, which is
why the thread must be sealed with hemp or Teflon tape.
After the gas has been connected, leak and function testing must be carried out by a registered gas fitter.
Changes to the service menu
Changes to the service menu can only be made within 1 minute of applying the voltage. If the appliance has already been connected
for a longer period, interrupt the power supply for about 10 seconds.
▸
With the hob switched off, hold the
and buttons depressed at the same time for 4 seconds.
–
An acoustic signal is emitted.
▸
Hold both sliders
to the left of the button depressed at the same time for 4 seconds.
–
An acoustic signal is emitted.
For appliance GAS411, simply press the single slider
.
▸
Use the
button to select the next highest and the button the next lowest user setting.
–
The current service menu item is shown in the timer display.
The current value under the corresponding menu item is displayed above the first active slide to the left of the button. Use the first
active slider to the left of the button to change the values. The left half of the slider functions as the minus button and the right half
functions as the plus button.
Menu item
Function
Default
setting
Setting
Description
Set gas type
Depending on article
12T, 20 mbar
20Y, 28 mbar
Software version number
of touch control
The current software version
is displayed: U-x-x-x.
Software variant number
of touch control
The current software variant
is displayed: P-x-x-x.
Display text
All displays illuminate.
Demo mode
The demo mode is switched off.
The demo mode is switched on.
▸
To save entries: Hold the
and buttons depressed at the same time for 2 seconds.
–
An acoustic signal is emitted.
–
The «Service menu» mode is ended.
