7
CONTROLS
1 ON/OFF switch
2 Thermostat adjusting knob
PRECAUTIONS
Before starting the machine, make sure that the inlet water supply is properly connected
(1 bar min., 4 bar max.), running dry, can damage the pump.
Always check that the exhaust smoke chimney and the air intakes are not obstructed.
As a safety measure for the worker and for the machine same, do not modify the H.P.
washer without the manufacturer permit in writing.
If You detect find a damage, before starting a working, immediately contact Your Dealer.
When using the H.P. cleaner, never cover it; however if You think that is necessary to
protect it, do it letting the air through so as to cool down the motor.
Switch the machine off, during longer idle periods (more than 15/20 minutes), and unload
the pressure in the machine by pulling the spraying gun trigger.
For working breaks of one hour or more, it is necessary to remove the electrical plug
from the electrical socket.
The maintenance works, requires the intervention of semi-skilled personnel that are also
acquantained with this instructions manual and all the same well-informed about the safety
general regulations as about the machine's specific safety systems.
For repair, special maintenance operations or for the setting up of the machine, apply to
the Customer Service Centre or to the authorized technicians only.
