-8-
5.1 ID of Doorstation Settings
5. Setup
1)Power-on within 10 seconds;
2)Press and hold "KEY2" button
for 3 seconds, it will enter the
setting state of prepare.
LED 1 Buzzer
beep+,beep
(red,flash)
Press and hold "KEY1" and
"KEY2" button for 3 seconds at
the same time, it will enter the
state of ID setting.
LED 1 Buzzer
beep+, beep
(off)
The ID of doorstation can be set to ID0/ID1/ID2/ID3.The default is ID0.
Followed by pressing the "KEY2"
button, each time you press
KEY2 to replace the ID;
Note:The ID will cycle between
ID0 ID1 ID2 ID3.
LED 1 Buzzer
beep one
(green,flash one)
ID0:
beep twice
ID1:
beep 3 times
ID2:
beep 4 times
ID3:
(green,flash twice)
(green,flash 3 times)
(green,flash 4 times)
Note: In all steps, if there isn’t any operation within 10s, or press Call button, it will exit
the setting, and the color of LED1 turns to red, and the buzzer sounds "beep, beep+".
