4.3.2 Turn backlight on: - Without Power Saving Mode
a.
Turn scale on
b.
Press and hold
2
c.
Backlight is turned on
NOTE
: Backlight under this mode will remain lit on until
manually turned off.
4.3.3 Turn backlight off
Press and hold
0
until backlight is turned off
4.4. INTERNAL FUNCTIONS SETTINGS
4 internal functions
1
are available. They are:
F1
Check offset value
F2
Check display segments
F3
Check span value
F4
Set auto power off
4.4.1 How to Enter the Functions Required
a.
Turn scale on by pressing
ON/ZERO
, then press and
hold
NUMBER SET
before scale completes counting down
b.
The
WEIGHT PANEL
shows
F1
c.
Press
NUMBER SE T
until the desired function number
appears
d.
Press
@WT/SET
to enter selection
e.
Press M+ to save and quit to normal operation status
4.4.2
Check Display Segments
(
F2
)
1
F1 and F4 are for qualified service personnel only. May be disable as requested by
metrological legislation of certain countries.
a.
Refer to the
4.4.1
on how to enter
F2
b.
Press
@WT/SET
c.
All display segments will be lighted up
d.
Check digits and arrow indications of all 3 panels
to verify any defects or errors
e.
Press
CLEAR
to quit
4.4.3 Set Auto Power Off Status
(
F4
)
This unit is equipped with
AUTO POWER OFF
function.
Default setting = auto off after 4 minutes unused. Fol low
the below steps to disable/employ the
AUTO POWER OFF
function.
a.
Refer to the
4.4.1
on how to enter
F4
b.
Press
@WT/SET
to shift between
0_OFF
and
4_OFF
*To disable the
AUTO POWER OFF
function select “
0-OFF
”
*To employ the
AUTO POWER OFF
function select “
4-OFF
”
c.
Press
@NUMBER SET
to confirm and return to other
function selection manual, or
d.
Press
M+
to save and quit
