Set-Up
17
81-0220-01 Rev R
1. Check to see if base mount has been mounted to the top of the darkroom. If not, use the
black screws or brass thumb nuts to install the mount.
2. Attach the camera bracket to the base mount with the brass thumb nuts.
3. Place the camera/lens assembly in the hole in the base mount, making sure that the label,
found on the camera, which states Front, is placed towards the front of the darkroom, fac-
ing the user.
4. Use the black thumb screw(s) to tightly secure the camera in place, attaching it through
the hole at the top of the bracket.
5. Plug the serial cable from the motorized lens into the lens controller.
6. Plug the camera cable into the top of the camera. Do not plug the other end of the USB
cable for the lens controller and camera, into the computer, until VisionWorks software
has been installed
Note:
When looking at the darkroom from the front, the 815 CCD and 515 CCD cameras
attach to the bracket with the Black Thumb Screw to the right and/or left of the system. The
USB and power cables will extend from the top of the camera, facing the user.
