Spanning Tree:
Enable
IGMP Snooping: Disable
So it’s shown that STP is enabled. To disable STP:
Switch# no stp
More commands:
To set a switch as root, you need to set its bridge priority value smaller than that of the
two others (priority: smaller means higher priority; default: 32768, range: 0-65535):
Switch# stp bridge priority <priority>
To disable STP calculation of a port
Switch# disable stp ports <port>
***port: 1-26
To check possible errors:
(1) You may need to see which switch is the bridge root:
Switch# show stp bridge
— Designated Root Information — -
Priority : 32768
MAC Address : 00:09:ca:01:75:02
Hello Time : 2s
Forward Delay : 15s
Max Age : 20s
— Bridge STP Information — -
Bridge Priority : 32768
MAC Address : 00:09:ca:01:75:02
Root Path Cost : 0
Root Port : 0
Bridge Hello Time : 2s
Bridge Forward Delay : 15s
Bridge Max Age : 20s
(2) You may need to see STP ports information:
Switch# show stp port portnumber ***port number (1=<A<=26)
Switch# show stp port 3
— Port Information -—
STP Port : Enable
Содержание iSpirit 3026
Страница 4: ...Part 1 Hardware Operation...
Страница 30: ...Part 2 Software configuration manual...
Страница 82: ...multicast address 01 00 5e 64 64 f0 vlan id 2 port list 1 2...
Страница 233: ...Figure 18 60 802 1 X Configuration Page Figure 18 61 802 1 X Port Configuration Page 4 802 1 x user display page...