DAX-‐16 Installation & Operation Manual
Rev 1.4
20
Appendix A
–
Connector Pin Outs
DE-‐15F Amplifier Outputs
The DAX-‐16 has eight DE-‐15F connectors to drive power amplifiers.
DE-‐15F Signals by Pin
Pin Signal
1
Channel A – input
2
Standbyn – Pulled low to put amplifier in standby
3
Channel A Vmon (output voltage monitor)
4 Channel A Imon (output current monitor – not used on DAX-‐16)
5
No Connect
6
Chassis Ground (shield)
7
Channel A +input
8
Channel B +input
9
+15V from amplifier (not used by CM-‐8E)
10
Signal Ground (reference for Vmon and Imon)
11
Channel B –input
12
No Connect
13
Channel B Vmon (output voltage monitor)
14 Channel B Imon (output current monitor, not used by DAX-‐16)
15
No Connect
RJ-‐45 AES Input
The DAX-‐16 uses the StudioHub pin out for AES/EBU over CAT5 or CAT6 Ethernet cable. These cables
are twisted pair and have the required characteristic impedance. The top RJ-‐45 connector carries digital
audio inputs 1 through 8. The bottom RJ-‐45 connector carries digital audio inputs 9 through 16.
Audio Channels
AES Pair
Top RJ-‐45 Pins ( +, -‐ )
1, 2
1
1, 2
3, 4
2
3, 6
5, 6
3
4, 5
7, 8
4
7, 8
Audio Channels AES Pair
Bottom RJ-‐45 Pins ( +, -‐ )
9, 10
5
1, 2
11, 12
6
3, 6
13, 14
7
4, 5
15, 16
8
7, 8
