DAX-‐16 Installation & Operation Manual
Rev 1.4
14
Figure 5 -‐ DAX16 Network Configuration.
9.
Connect the power amplifiers to the DE-‐15 (HD-‐15) connectors on the rear panel of the DAX-‐16.
These connectors use industry-‐standard pin out (as shown in Appendix A).
10.
Connect the digital outputs of the sound processor to the digital audio RJ45 connectors on the
back of the DAX-‐16. In AES/EBU systems, connector A carries AES/EBU channels 1 through 8.
Connector B carries channels 9 through 16. In BLU link systems, connector A is the IN port, and
connector B is the OUT port. The IN port should be connected to the OUT port of the previous
device in the loop. The OUT port should be connected to the IN port of the next device in the
loop.
11.
If multiple DAX-‐16 are in one location, connect an RCA cable from each unit to the next. These
cables bus the audio streaming mix bus allowing audio from multiple DAX-‐16 units to be
monitored on a single stream. The two connectors on each unit are connected together
internally, so it does not matter which connector is used.
12.
Click the Audio link at the top of the configuration page. The audio configuration page is shown
in Figure 6.
