12
Moisten the sponge pad with cleaning fluid and wipe down the Heat Shoes to remove any
debris.
Notes:
Be certain that the Heat Shoes are cooled down to room temperature when cleaning to
avoid the chance of burns.
Use cleaning fluid sparingly; Do Not allow it to “run” onto wiring or into the “ends” of
the laminator.
The Heat Shoes are Teflon coated and can be easily scratched; use care when cleaning
them.
Cleaning the Rubber Rollers
With continuous use, the Rubber Rollers will accumulate adhesive and dirt. If indentations or
bumps begin to appear on the surface of the finished lamination, or the Rubber Rollers have
“shiny” spots on them, cleaning is necessary. Use a dry Scotch Brite® scrubbing pad to cut
through adhesive deposits. Turn the Speed Control Knob to a slow speed setting and toggle the
Motor Drive Switch between the “FORWARD” and “OFF” positions to advance the rollers and
clean all areas. Proceed to wipe the rollers clean using the sponge pad moistened with cleaning
fluid.
Notes:
Be certain that the laminator has cooled down to room temperature when cleaning the
Rubber Rollers to avoid the chance of burns.
Use cleaning fluid sparingly; Do Not allow it to “run” onto wiring or into the “ends” of
the laminator.
Do Not use knives, scissors, any sharp metallic objects or steel wool to clean the Rubber
Rollers. Use of such objects will damage the rubber surfaces and require replacement of
the rollers. Damage of this nature is not covered under the Manufacturer’s Warranty.
For additional maintenance and service procedures call USI Technical Assistance (800-752-
9131) for recommendations.
