Ushio UIT-250, Руководство по эксплуатации

Страница: 4 / 40

ii
1000033244-00
Caution
•
When placing the UV radiation hardening equipment on a conveyor, attach a heat
shield cover on the UIT-250. If used without attaching a heat shield cover, there
is the possibility that the operating panel will be damaged beyond repair.
•
Allow 1 minute intervals between measurements.
If measurement is repeated without allowing for sufficient cooling, the unit will
overheat and measurements can no longer be performed.
•
The temperature limitation for use is 300
°
C for no longer than 10 seconds.
When using a sampling rate of 16 samples/second, as accumulation over 4 min-
utes and distribution measurement are possible, be careful when taking measure-
ments at high temperature.
•
The photodetector is formed using optical components; therefore pay attention
to the environment (temperature and humidity). Especially the optical filter
which demonstrates prescribed functionality within the specified temperature
and humidity environment. In conditions outside the specified environment func-
tionality can not be demonstrated and the element itself deteriorates. Store in a
location where the environment such as the temperature and humidity can be
controlled such as using a desiccator.
•
Do not apply any shock to the UIT-250 unit and the photodetector. Otherwise,
the incorporated devices may be broken or fail to operate properly.
•
When replacing the photodetector, be careful not to touch the gold-plated con-
nector. Touching the connector may cause rust. If you accidentally touch the
photodetector, wipe it with alcohol-soaked gauze.
•
Use alcohol to clean the UIT-250 unit. Do not use any organic solvent such as
thinner or acetone since it damages the unit body.
Read the following cautions prior to use of the
unit.