US Water Systems 080-FSC-075, Руководство пользователя

Страница: 10 / 25

10 US Water Focus Premium Economy Water Softener | 080-
Visit us online at www.USWaterSystems.com Give us a call at: 1-800-608-8792
Installation Instructions
1. If your hot water tank is electric, turn off the power to it to avoid damage to the element
in the tank.
2. If you have a private well, turn the power off to the pump and then shut off the main wa-
ter shut off valve. If you have municipal water, simply shut off the main valve. Go to the
faucet, (preferably on the lowest floor of the house) turn on the cold water until all pres-
sure is relieved and the flow of water stops.
3. Locate the softener tank and brine tank close to a drain where the system will be in-
stalled. The surface should be clean and level.
4. Connect the inlet and outlet of the softener using appropriate fittings. Perform all plumb-
ing according to local plumbing codes.

ON COPPER PLUMBING SYSTEMS BE SURE TO INSTALL A GROUNDING
WIRE BETWEEN THE INLET AND OUTLET PIPING TO MAINTAIN GROUND-
ING.
Any solder joints being soldered near the valve must be done before connecting any piping
to the valve. Always leave at least 6" (152 mm) between the control valve and joints being
soldered when soldering pipes that are connected to the valve. Failure to do this could
cause damage to the valve.
The Focus is equipped with 3/4” male NPT connections. It is recommended that these con-
nections are made using Teflon tape.
The inlet and outlet can be identified on the bypass valve. There are arrows stamped in the
bypass valve showing flow. The arrow pointing toward the valve is the inlet and the arrow
pointing away from the valve is the outlet.
All piping should be secured to prevent stress on the bypass valve and connectors.