US Shift Quick 4, Руководство пользователя, Страница: 3 / 12

3
INTRODUCTION
The built-in Quick 4 User Interface allows most sensor values to be viewed, while
also allowing the transmission to be manually shifted. With firmware version 3.0 or
later, self-contained, basic tuning of transmission settings is also possible via the
tuning menu. In addition, a computer running our included tuning software can be
connected to provide advanced tuning options.
___________________________________________________________________
MAIN MENU
For most selections in the main menu, the three letter mode name is shown on
the display for 2.5 seconds after the mode is selected by rotating the function
knob. The mode name is also displayed at any time when the function knob is
pressed in (in all modes other than "Status" and “Tuning” modes).
OFF
In this mode the display is blank and nothing is shown.
StA = Status Display
This mode is the default display mode. The first character indicates the selected
transmission range (P, r, n, o, d, 2, 1). or "E" if there is an error with the PRNDL
switch (range sensor or pressure switch module). The second character is
normally blank, but will show "P" if Manutronic Pushbutton shift mode is active or
an "L" if manual selection mode is active. The third character indicates the
currently commanded or selected transmission gear. There is also a small dot at
the upper-left-hand corner of the third display character (similar to an apostrophe).
This dot will illuminate when the torque converter clutch is engaged.