Step 4
Install software and register
your modem.
Re-insert the Installation CD-ROM. The installation
utility should start automatically. The Setup Wizard on
the CD-ROM guides you through installing the
program group (including Internet Call Notification,
ControlCenter, and optional faxmodem software) and
registering your modem.
NOTE:
If the Installation CD-ROM interface does not
run automatically, click Windows Start
Start
Start
Start
Start and then click
Run
Run
Run
Run
Run. In the “Run” dialog box, type D:\setup.exe
D:\setup.exe
D:\setup.exe
D:\setup.exe
D:\setup.exe. If
your CD-ROM drive uses a different letter, type that
letter in place of “D.”
If you have Windows Me/98/95
Click Windows Start
Start
Start
Start
Start, Settings,
Settings,
Settings,
Settings,
Settings, and then Control Panel
Control Panel
Control Panel
Control Panel
Control Panel.
Double-click the Modems
Modems
Modems
Modems
Modems icon. In the Modems
Properties screen, you should see a description for
your modem, U.S. Robotics V.92 Fax Win Int. If you do
not see a description of your modem, see the Note
after this section. If you do see the description, click
the Diagnostics
Diagnostics
Diagnostics
Diagnostics
Diagnostics tab. Make sure that the correct COM
Port (modem) is highlighted. Click the More Info
More Info
More Info
More Info
More Info
button. You should see a series of commands and
responses from the modem. This means that the
installation was a success. If you do not see commands
and responses, see the Note after this section.
NOTE:
If your modem is not listed and/or you do not
see a series of commands and responses, make sure
that your internal modem is physically installed
correctly in your computer. With the power off, press
the modem in firmly so that it is seated properly in its
slot. When the modem is installed correctly, you will no
longer see any part of the gold edge. If your modem
still does not work, you may need to remove it and
reinstall it in another available slot. Shut down and
restart your PC. Check your modem again using Control
Panel as described previously.
