US Conec Loose Fiber Ribbonizing Tool, Записки инженера-прикладника

Страница: 7 / 10

Document Title: Operating Instructions for the US Conec
Loose Fiber Ribbonizing Tool
Document Number: AEN-1408 Rev 2.0
7 of 10
4.2a 4.2b
CAUTION: Make sure the fibers remain in the proper order during this step.
Attention is required to ensure fibers do not cross.
4.3 Place a new razor blade or Xacto
®
knife against the outside of the tray at the end
opposite the stacker. Hold the blade at an approximate 45° angle to the edge of
the tray.
4.3 4.4
4.4 Carefully slide the blade along the edge of the tray to remove the excess tape.
Pull the tape away from the tray with your other hand as the blade is moved.
Attention is required to ensure the tape is cut as closely as possible against the
edge without fiber damage.