Urschel COMITROL 1700, Инструкция по эксплуатации

Страница: 41 / 233

To resharpen fabricated cutting heads:
1. Remove cutting head from machine.
See “Disassembly”, page 36.
2. Use appropriate file. See chart page 38..
Use square, second cut, mill files and cor-
responding flat files depending on cutting
head size.
3. Place cutting head in a soft jaw vise
and file from outside to center.
File in
one direction at a 45° angle to the land of
the cutting surface (Figure 22, page 38).
NOTE: Cutting head can be sharp-
ened until the land of the cutting edge is
filed to approximately 1/32" (.794 mm) in
width, then a new cutting head is
required.
4. Remove burrs on inside of cutting
head
by honing each vertical land or
running an emery cloth counterclockwise
inside cutting head.
39
MAINTENANCE
Cutting Heads