41
DS1168-013C
NUMBER OF ENABLED BUTTONS
This parameter can be used to enable call buttons (2) and (7) present on the front part of the door unit. Specifically,
the buttons can be enabled to “ONE ONLY” of these (only the right button), both buttons (“BOTH”) or neither of
the two (“NONE”).
Function possible if the ADVANCED CALL BUTTON CONFIGURATION is set to DISABLED.
DOOR UNIT TYPE: SECONDARY
If “SECONDARY” value is selected in the DOOR UNIT TYPE parameter, the three new parameters described
below will be present on the SETTINGS
web page:
SECONDARY DOOR UNIT COLUMN ADDRESS
If the door unit is secondary, its RESPECTIVE COLUMN ADDRESS must have a value between “0” and “31”, and
must coincide with the column ID set on the column interface (Ref. 1083/50) which powers it.
SECONDARY DOOR UNIT ADDRESS
In the same column there may be two secondary door units which must have different PE addresses [or door unit
ID]; the values which may be assumed are “0” or “1”.
SECONDARY DOOR UNIT CALLING BUTTON OFFSET
If two door units are configured as secondary in a column and you want each one to call a different group of
users, enter the code on one of the door unit, to be associated with the first button (offset) of the door unit being
configured.
The offset code may be comprised between “0” and “127”.
Normally the parameter in this type of use must be left at 0. For further details, refer to section
3m - Alpha Panel on the Urmet website.
AUTO-ON RESTRICTION ACCORDING TO APT ADDRESS PARITY (#)/(&)
The parameter enables or disables users with even ID code to be able to use auto-on video mode only on
door
units with even address ID=0 (if secondary) or ID=2.
As a result, users with odd ID codes will be able to use video auto-on mode only on
door units with odd address
ID=1 (both main and secondary) or ID=3.
During auto-on, the audio line (if the user has entered a conversation) and the door opener service will also be
available on the selected door unit.
The function works with both main and secondary video door units Ref. 1083/48 and 1083/39 (*),
except in the case of the main door unit with ID=0, on which it is essential for each user to activate
auto-on.
So in this case the parameter will not be visible on the SETTINGS
screen.
The described filter only works when the function is activated on the installed door units. When it is not
programmed, the odd and even user codes are not differentiated. For example, with function active
on main door unit 1 (odd) and deactivated on main door unit 3 (also odd), the user with ID 16 (even)
will not be able to use the auto-on function on main door unit 1 but will be able to do so on main door
unit 3.
(
*
) Function available only if the door unit Ref. 1083/39 has parameter “NUMBER OF EXTERNAL
CAMERAS” different from 0.
