An unlimited number of receivers may be connected together to form a radio bus. This makes it possible to:
• send controls to groups of receivers on the radio bus (see “Radio Memo”)
• send a control from a transmitter to a receiver which is out of direct range
• centralise operation of all lights or all window shutters.
All receivers (MTR1300EBRP, MVR500EBRP, MTV150EBRP and also the traditional modules MTR2000ERP, MVR500ERP
and MTV500ERP.) are compatible with the radio bus. The window shutter controls may also be sent via lighting modules and
vice versa. See the “Radio Memo” or go to
www.yokis.com
for more information on the radio bus.
Note:
For correct operation of the YOKIS radio bus, the receiver modules must all be connected to the same power phase (L)
and there must be no phase (L) and neutral (N) reversals on any receiver module. Follow the installation diagrams carefully.
HOW TO INCREASE THE RANGE USING AN INTERMEDIATE RECEIVER
1. Define a radio bus between receivers as described above.
2. Connect the transmitter to the receiver to be controlled by pressing the chosen pushbutton on the transmitter (E)
5
times.
Press the "Connect" button on the receiver (R) while the transmitter LED is blinking.
3. At this point, create an access point on the receiver nearest to the transmitter by pressing the transmitter (E) pushbutton
7
times (the same one programmed in the previous step). The transmitter LED will start flashing rapidly. Press the "Connect"
button once on the receiver (R): the transmitter and receiver LED will stop blinking.
DS1054-066B
P9
RADIO BUS MODE
Led
Connect
Led
Connect
Led
Connect
Led
Connect
R1
R1
R1
R1
R1
R1
HOW TO CREATE A RADIO BUS BETWEEN RECEIVERS
Press “Connect” on receiver 1. Its LED will start flashing
.
While the LED is flashing, press “Connect” on receiver 2
.
To confirm the connection, the LED of receiver 2 will flash once and the LED of receiver 1 will stop flashing. The relays of the
two receivers will switch once when the connection has been established.
Possible with all
Yokis receiver
Unlimited number
of receivers on the
radio bus
A command can be centralised by repeating the same procedure on up to four receivers. In case that more than 4 receivers
should be driven, use the Radio Bus.
DIRECT MODE CENTRALISATION
RADIO BUS CENTRALISATION
The following five steps are needed for centralisation:
1. Create the radio bus between receivers
Follow the procedure described above.
2. Connect the pushbutton of the transmitter to the nearest receiver
(it is advisable to connect the transmitter to the nearest receiver to avoid problems of range)
1. Press the chosen pushbutton on the transmitter
5
times.
2. While the transmitter LED is blinking, briefly press the area near where the "Connect" label of the receiver is marked.
3. The receiver will switch the relay briefly and the transmitter LED will go out.
E5
R1
R1
R1
E7
L
N
