urmet domus 1061/006A, Инструкция по установке и программированию

Страница: 58 / 68

58 DS1061-036A
7.4 DETECTOR
7.4.1 Detector addition
To add a detector to a control panel input, follow the instructions below :
1. Activate the system maintenance mode (see paragraph
7.1 MAINTENANCE PROCEDURE
).
2. Open the control panel.
3. Unpower the control panel.
4. Disconnect the control panel backup battery.
5. Add the new detector, following its instructions. If the input to be used has already other detectors
connected, the new device must be
compatible with the existing ones. For further information, refer to
instructions in chapter 4.
6. Connect again the backup battery and power again the control panel.
7. If the new detector has been connected to a unused input, perform the input configuration.
8. Close the control panel to exit from the maintenance procedure.
7.4.2 Detector deleting
To delete a detector, follow the instructions below :
1. Activate the system maintenance mode (see paragraph
7.1 MAINTENANCE PROCEDURE
).
2. Open the control panel.
3. Unpower the control panel.
4. Disconnect the control panel backup battery.
5. Remove the detector.
6. Connect again the backup battery and power again the control panel.
7. If the detector was the only connected to the input, program the input as “Not used”.
8. Close the control panel to exit from the maintenance procedure.
7.4.3 Detector replacement
To replace a detector with an equivalent device, follow the instructions below :
1. Activate the system maintenance mode (see paragraph
7.1 MAINTENANCE PROCEDURE
).
2. Open the control panel.
3. Unpower the control panel.
4. Disconnect the control panel backup battery.
5. Replace the old detector with the new one.
6. Connect again the backup battery and power again the control panel.
7. Close the control panel to exit from the maintenance procedure.
7.5 ADDITION OF A CONTROL PANEL OPTIONAL DEVICE
To add an optional device to the control panel, follow the instructions below :
1. Activate the system maintenance mode (see paragraph
7.1 MAINTENANCE PROCEDURE
).
2. Open the control panel.
3. Unpower the control panel.
4. Disconnect the control panel backup battery.
5. Add the optional device in the control panel, by following instructions in chapter 4.
6. Connect again the backup battery and power again the control panel.
7. Program the functions available with the new option.
8. Close the control panel to exit from the maintenance procedure.