urmet domus 1061/006A, Инструкция по установке и программированию

Страница: 46 / 68

46 DS1061-036A
When an event occurs, the telephone communicator starts sending alarm calls to every telephone number
associated to the event, in sequence.
If in the control panel there are both the PSTN telephone communicator and the GSM module, with Primary
telephone channel parameter, it is possible to identify which device must be used as priority channel for
alarm calls. If the primary telephone channel is not available, (for example for PSTN line failure or no GSM
network), is automatically used the other one.
Telephone number entering
To enter a telephone number, follow the instructions below:
1. Press OK button to select the desired memory location (t1, t2 … t8).
2. Enter the telephone number, using the “arrow” button; digits scroll in sequence, character P inserts a
1 second pause.
3. Press OK button to confirm.
4. Repeat from step 1 until the whole telephone number has been entered.
5. Keep OK button pressed for 2 seconds to confirm the whole telephone number. The telephone
number scrolls on LCD display in order to check it and appears the dot down on the right.
WARNING !! The phone number “112” can not be used for alarm calls.
Check of a telephone number already programmed
To check a telephone number already programmed (the stored telephone numbers are indicated by the dot
down on the right corner of LCD display), press
OK button. The number will appear on display, one digit at
a time, blinking on the right.
Telephone number deleting
Select the desired memory location (t1, t2 … t8) and keep OK button pressed for 2 seconds. The LCD
display blinks for 3 times and disappears the dot down on the right.
WARNING
: Using a PC and the suitable software, it is possible to customize an higher number of
telephone parameters. For further information, see paragraph 5.5.3 Telephone communicators
configuration .