© Urban Coop Company, all rights reserved.
Fig 1
Fig 2
Figs 1 and 2
Center one B5 eave board along top beveled edge of roost making sure equal amounts hang off of
each end, and top edge is butted up tight against notches in roost ends. After positioning, attach using four E2
green screws, screwing into pre-drilled holes. Repeat for other side using remaining B5 eave board.
8
Eave Boards
Roof Install
9
CAUTION:
Any metal roof panel may have edges that are sharp enough to cut you. Be careful!
Fig 1
Attach one edge of the B6 Galvalume roof panel onto one of the B5 eave boards, centering it from end to
end. Using E3 rubber clad washer screws and the bit holder, attach one edge of panel to eave, taking care to
make sure roof lays down smoothly. Gently roll roof over to other side, positioning roof where panel bends
smoothly over roost ends and lays down snug. Leave a little gap similar overhang on end. Attach other side using
four E3 rubber clad washer screws.
Fig 1
