© Urban Coop Company, all rights reserved.
Fig 1
Fig 2
Fig 3
Fig 1
If you ordered your feeder at the time of your coop purchase omit step one, as we will have cut opening for
you. If not, cut out a pattern of squares in the wire on either end of the left side of the coop. The square should be
5”
wide x 10” tall (keeping in mind one wire hole is ½”x 1”) starting 6 inches (6 openings) up from the bottom
. Use
strong wire cutting pliers as the wire we use is very tough.
Fig 2
Place the feeder into the hole, and install provided hasp and clip as shown as security against a predator
knocking over and pulling out feeder, resulting in a large, exposed hole. Use small phillips screws and clip in your kit.
Optional Feeder Install
10
Optional Waterer Install
Fig 1
Fig 2
Optional Waterer Installation
Fig 1
If you ordered your waterer at the time of your coop, we have cut out the install hole for you. If not,
starting 3” from the top (closest hole), cut out 1 full width of wire and 5” down so that the D1 waterer bracket can
be inserted as shown and screwed to panel rail using two E2 green screws.
Fig 2
All coops have a waterer hole, but if you did not order your waterer at the time of your coop, you will need
to remove the wire that is covering the hole. We install it using shorter staples, so pliers should be able to pull it
out from the back side. Force fit nipple into waterer grommet at far end, then carefully pass waterer through
hole. Hang far end of waterer into bracket capturing the end cap behind the bracket against back wall. Fill. :)
11
See detail Y1 on next page
for instructions on inserting nipple
into the tube.
