UR FOG Plus Series, Инструкция по установке и эксплуатации

Страница: 8 / 10

8
8 DESCRIPTION OF INPUT AND OUTPUT CONNECTIONS
While connecting the machine to the mains power, it is raccomended to never disconnect existing ground cable.
The fact of disconnecting or modifing existing cables voids the warranty and can cause troubles or accidents
related to the temperature control.
Discrete signals port
The discrete signal port is hosted on a multiple way screwed connec-
tor, visible on the right side of Fig. 1.
In Tab. 1 is indicated the pinout, along with some important notes
about each signal.
IMPORTANT: the descriptions in Tab. 1 are valid if DIP-SWITCH 4 is
on OFF position (passive security, relays are normally NOT active).
The signals present on this port will always be available to the user
and will work in parallel with the commands received by the serial
interface. In no case a voltage greater than the board’s power supply
should be applied to any pin of this port, except for relay outputs that
can manage up to 60V, 500mA. Some interface options depend on
S3 (Dip Switch) configuration and W1 and W2 jumpers: Fig.2 shows
their position on the board.
FUNCTION
DIP
SWITCH
fig 1
Tab. 1
13
11 INSTALLATION, EXCHANGE AND BAG RESET
N.B. When you close the cover, the buzzer will make a sound to confirm the tamper is closed.
Attention: Before opening the cover, make sure that the alarm control panel is in “service”
mode, so that the opening of the “anti-sabotage or tamper” circuit does not cause any alarm.
After that, insert a new bag until you hear the “click” of the metal plug (pictures at page 17) entering in its housing, then close the door.
Insert the plastic bag in the compartment as shown in
the picture
metal plug