- The battery is necessary to use the system in a safe way. The battery is
recharged by system board.
- The placing of the lead-acid battery 2 Ah DC 12 V is under the heat
exchanger, in flat position with poles facing the plastic cover.
- In order to accede to the battery case is necessary to remove the frontal
cover.
7
7
MAINS POWER AND POWER SUPPLY CONNECTIONS
Mains power (110V or 230V ) source supplies energy to the heating system and to the internal power supply. A DC 12v 2.0Ah battery
(not included ) must be connect to the recharge circuit to allow unit to shoot even without mains power. The heating element is of 180W,
at the heating startup the power consumption is about 170W and in some minutes it goes down. The average consumption range is from
around 37 W (Modular 2) to 53 W (Modular 8). Ambient temperature and battery loading can influence the average power consumption.
Do not use inverter or UPS if you are not sure that they generate a true sine wave, not a rebuilt one. Please refer to the UPS
manufacturer the correspondance of such features before proceeding with the connection.
-The max current to be considered for the system is 3,15A
-The connection to the electricity grid (110v or 230V ) must be performed by a qualified technician.
-Connect the equipment to the electricity grid only after you have completed the installation.
- It is necessary to connect the ground terminal.
- The system must be connected to the mains trough on automatic switch (automatic switch, curie C, with I
h=
10 A and I
dif=
30 mA,...)
with breching capacity based on the assumed fault current of the fogging system in the sampling point.
PLEASE NOTE THAT, AS ALL POWERED EQUIPMENT FROM THE ELECTRICITY GRID REQUIRING INSTALLATION,
IT IS SUBJECT TO COMPLIANCE WITH RULES OF THE COUNTRY IN WHICH IT IS INSTALLED
For section and types of wires, fuses, suitability of materials to installation sites etc..
REPLACE FUSE ONLY USING SAME TYPE ,FOLLOWING THOSE SPECIFICATIONS:
CERAMIC BODY FILLED WITH QUARTZ, REF. STD. EN60127-2-3/DIN41660 3,15Ah (EXAMPLE OMEGA GT520231)
1
- Power supply main connections
2
- Mains power
3
- Ground connection
4
- Battery holder (battery not included)
1
2
3
4
4
14
12
FRONT LEDS MEANING
RED LED
(right)
ON:
Error (Empty bag or low fluid , Mains power off/Battery low) or Fault
OFF : No error condition
BLU LED
(center)
ON:
Unit is armed and ready to shoot (with green led ON).
OFF:
Unit is disarmed , shot not possible.
GREEN LED
(left)
ON:
Unit has reached the correct temperature
OFF: Unit in warming condition, no shot possible
.
The top right RED led light (DL1) means unit is powered on. The RED FAULT led (DL7)
is located in the middle of the board.
EMPTY BAG
ARMED AND
READY
WARMING
Содержание Plus Series
Страница 1: ......
