Upright ULII-25, Руководство по обслуживанию и запасным частям

Страница: 16 / 113

Operation
3-6
Section
UL-25/32/40/48 Portable Personnel Lifts
3.4
3.4 Transporting
UL-25,32,40 ONLY
Note: The loading instructions that follow are to
be used for UL-25,32, and 40. The UL-48 is not
equipped with a loader (see next page for UL-48
transportation instructions).
DC Models
Disconnect the plug from the battery box and remove
the battery box from the rear of the machine (fig. 3-1).
The battery box is heavy, 75 lbs. (34 kg),
lift properly (or have someone help you)
to prevent back injury.
Make sure loader fully engages tailgate
or vehicle bed.
Loading
1. Raise the loader support bracket and engage the
retaining pin in the top hole of the loader channel
(fig. 3-3).
2. Secure the loader to the loader support bracket
with the gravity hook (fig. 3-3).
3. Position the unit so the back of the machine
comes in contact with the vehicle bed or tailgate.
4. Release the gravity hook and slide the loader
down until it comes into contact with the vehicle
bed or tailgate (fig. 3-3). Then reposition the
loader support bracket so the retaining pin is in
the first available hole above the loader.
Figure 3-3: Loader in load position
Loader Channel
Retaining Pin
Loader Support
Bracket
Gravity Hook
Loader
Tailgate
5. Release the locking pin and pull the Lifting Arm out
until the locking pin engages the hole in the end of
the Lifting Arm (fig. 3-4).
6. Lift up on the Lifting Arm, using the loader as a
pivot, until the unit rotates to a horizontal position
in the vehicle bed (fig. 3-5).
7. Push the base of the unit towards the front of the
vehicle bed. The machine will slide on the loader
until the rear wheels are on the bed. The unit may
then be rolled on the rear wheels and upper casters.
8. Return the Lifting Arm to the stored position, making
sure the locking pin engages the Lifting Arm.
9. Secure the unit with suitable strength rope or tie
straps using the forklift pockets located under the
base of the unit and either the upper caster axle on
UL25 models or the tilt back frame on UL32 and
UL40 models.
To prevent damage to the mast assembly,
do not place rope or tie straps across the
mast assembly when securing the unit for
transportation.
DO NOT overtighten the rope or tie
straps, damage to the machine will result.
Figure 3-4: Lifting Arm positioning
Locking Pin
Lifting
Arm