Upright SB-80, Руководство по обслуживанию и запасным частям

Страница: 30 / 186

3-6 SB80 Work Platform - European
M
AINTENANCE
Section
3.5
3.5 L
UBRICATION
Refer to Table 3-1 for the lubrication intervals and
Figure 3-4 for location of items that require lubrica-
tion service. Refer to the appropriate sections for
lubrication information on the Steering Linkage,
Torque hubs, Hydraulic Oil, Filter, and Engine Oil and
Filter.
Grease fittings
Wipe each grease fitting before and after greasing.
Using multipurpose Molylube grease in a grease gun,
pump the grease into the fitting until grease just
begins to appear at the edges of the pivot, wipe off
any excess grease.
Lubricating Turret Gears
Using a brush, apply open gear grease to the turret
gears.
Figure 3-4: Turret Gears
Figure 3-5: Turret Bearing Grease Zerk (shown from
below)
Hydraulic Oil and Filter
Fluid Level
With the platform fully lowered and boom fully
retracted, check oil level on sight gauge. If the oil is
NOT in operating range, add hydraulic fluid until oil is
visible in operating range on dipstick or visible in
sight gauge. DO NOT fill above operating range or
when the platform is elevated.
Oil and Filter Replacement
1. Operate the platform for 10-15 minutes to bring
the hydraulic oil up to normal operating tempera-
ture.
2. Provide a suitable container to catch the drained
oil.
3. Remove the drain plug and allow all oil to drain
into the container. Be sure to dispose of oil prop-
erly.
4. Reinstall the drain plug.
5. Remove filter element from filter head (located
beside valve block).
6. Apply a thin film of clean hydraulic fluid to the
gasket of the replacement filter.
7. Thread replacement filter onto the filter head until
the gasket makes contact then rotate 3/4 of a turn
further.
8. Fill the hydraulic oil tank to operating level on
sight gauge with hydraulic fluid.
NOTE: For service Information on the engine
refer to your engine manual (located in plat-
form manual box or available from UpRight
Inc.).
C A U T I O N
! !
The hydraulic oil may be hot enough to cause
burns. Wear safety gloves and safety glasses
when handling hot oil.